Note: This message is displayed if (1) your browser is not standards-compliant or (2) you have you disabled CSS. Read our Policies for more information.
On July 23, 2008, U.S. EPA finalized the new area source National Emission Standards for Hazardous Air Pollutants (NESHAP) regulation that affects emissions of Metal Fabrication and Finishing operations as well as Metal Plating and Polishing operations. This rule requires new management practices, pollution prevention strategies and equipment standards for metal fabrication/finishing operations and metal plating/polishing operations. The standards apply to operations that are an area source of the compounds of cadmium, chromium, lead, manganese, and nickel, or volatile organic HAP (VOHAP) and have the potential to emit less than 10 tons per year of any single Hazardous Air Pollutant (HAP) or less than 25 tons per year of a combination of HAPs.
The regulation contains requirements for general production processes like dry abrasive blasting, dry grinding and dry polishing, machining, spray coating and welding. The following nine source categories of metal fabrication/finishing operations are affected:
The following activities engaged in by metal plating/polishing operations are affected:
The new requirements for metal fabrication and finishing involve minimizing dust generated from abrasive blasting, grinding and polishing, operating all equipment in accordance with the manufacturer’s instructions, proper cleaning and storage of spray guns and painter training, and using welding processes with reduced fume generating capabilities. All affected sources must submit an Initial Notification, Notification of Compliance Status, and an annual Certification and Compliance Report. Existing sources have three years but new sources must submit no later than November 20, 2008 or 120 days after start-up.
The requirements for metal plating and polishing entail the use of wetting agents/fume suppressants while operating electroplating, electroforming, or electropolishing tanks. While plating, limit the "flash" or short term electroplating operations to one hour per day or three minutes per hour. Electroplating tanks that utilize a cyanide bath must ensure that the pH of the tank is maintained at 12 or greater. An emission control device will have to be operated on dry mechanical polishing or thermal spraying. All affected sources must submit an Initial Notification, Notification of Compliance Status, and an annual Certification and Compliance Report. Existing sources have two years and new sources must submit upon start-up.
Note: There is no specific form required for initial notification. U.S. EPA provides Initial Notification Examples.
To learn more about the National Emission Standards for Hazardous Air Pollutants: Area Source Standards you can access the Metal Finishing and Fabrication Final Rule and the Metal Plating and Polishing Final Rule. A quick breakdown of the rules and requirements can be found in the U.S. EPA Fact Sheets for Metal Fabrication and Finishing Categories and Metal Plating and Polishing Operations.
If you have questions and would like to speak with a CTAP staff member please contact (800) 988-7901 or, via email, ctap at idem.in.gov.